EKHO EK-WL8-AU 일반 설명 매뉴얼 - 페이지 5

{카테고리_이름} EKHO EK-WL8-AU에 대한 일반 설명 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EKHO EK-WL8-AU 8 페이지. Wireless optical smoke sensor with integrated voice annunciator and visual alarm device (vad)

페이지 인쇄

EK-WL8-OV/AU

WIRELESS OPTICAL SMOKE SENSOR

WITH INTEGRATED VOICE

ANNUNCIATOR AND VISUAL ALARM

DEVICE (VAD)

STFV.425238.037-AU-UM rev. 24

06.11.2020

Page 5 from 8

TESTING

An alarm test can be performed with a magnet by

placing it onto the outside of the sensor (opposite

side to the base alignment marks) the sensor

should take around 1 second to activate.

A suitable smoke test tool can also be used,

please follow the instructions to apply smoke to

the sensor in the correct way.

ANALOG DATA

The device provides the translator module with analog data about the current smoke

level, air temperature, dust in the chamber as well as voltage levels on its batteries.

This information can be viewed in the "Ekho Configuration" software.

By analyzing the voltage or dust levels, you can manage maintenance procedures

and predict when you will have to replace the batteries or clean the smoke sensors.

Please refer to the software manual for full instructions on how to use the program for

system maintenance.

SOUNDER

The EK-WL8-OV sounder can produce three messages (only 1 message can be

played at a time).

For successful operation it is necessary that the message number set in the translator.