EKHO EK-WL8-H 매뉴얼 - 페이지 4

{카테고리_이름} EKHO EK-WL8-H에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EKHO EK-WL8-H 6 페이지. Wireless heat sensor

EK-WL8-H/AU

WIRELESS HEAT SENSOR

STFV.425238.034-AU-UM rev. 14

10.08.2020

Page 4 from 6

TESTING

An alarm test can be performed with a magnet by

placing it onto the outside of the sensor (opposite

side to the base alignment marks) the sensor

should take around 1 second to activate.

A suitable heat test tool can also be used, please

follow the instructions to apply heat to the sensor

in the correct way.

ANALOG DATA

The device provides the translator module with analog data about the current air

temperature and voltage levels of its batteries. This information can be viewed in

the "Ekho Configuration" software.

By analyzing the voltage levels, you can manage maintenance procedures and

predict when you will have to replace the batteries. Please refer to the software

manual for full instructions on how to use the program for system maintenance.

WARNINGS & LIMITATIONS

Devices use high quality electronic components and plastic materials that are highly

resistant to environmental deterioration. However, after 10 years continuous

operation it is advisable to replace them to reduce the risk of reduced performance

caused by external factors. Ensure the devices are only used with compatible

control panels. Detection systems must be checked, serviced and maintained on a

regular basis to confirm correct operation.

Refer to and follow National Codes of Practice and other internationally recognized

fire engineering standards. Appropriate Risk Assessment should be carried out

initially to determine correct design criteria and updated periodically.

All devices are covered by a 3-year limited warranty (does not apply to batteries).

The warranty is voided by mechanical or electrical damage caused by incorrect