EKHO EK-WL8-OH 빠른 시작 매뉴얼 - 페이지 4

{카테고리_이름} EKHO EK-WL8-OH에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EKHO EK-WL8-OH 7 페이지. Wireless multi-sensor sensor

STFV.425238.032-AU-UM rev. 16

SMOKE SENSITIVITY

Smoke sensitivity level can be changed in translator menu.

WL8-TRH

vXX/RFYY

Configuration

Maintenance

3 sensitivity options are available, these can be selected only by using the translator

menu or the Ekho configurator software (setting via the control panel will have no

affect and sensor will remain in the selected mode).

TESTING

An alarm test can be performed with a magnet by placing it onto the outside of the

sensor (opposite side to the base alignment marks) the sensor should take around

1 second to activate.

A suitable smoke or heat test tool can also be used, please follow the instructions

to apply smoke/heat to the sensor in the correct way.

ANALOG DATA

The device provides the translator module with analog data about the current smoke

level, air temperature, dust in the chamber and voltage levels of its batteries. This

information can be viewed in the "Ekho Configuration" software.

By analyzing the voltage or dust levels you can manage maintenance procedures

and predict when you will have to replace the batteries or clean the smoke sensor.

Please refer to the software manual for full instructions on how to use the Ekho

Configurator for system maintenance.

Password

Radio

Signal line

Start Addr

EK-WL8-OH/AU

WIRELESS MULTI-SENSOR SENSOR

10.08.2020

001 wl8-trh

002 wl8-o

003 wl8-oh

Page 4 from 7

Delete

Edit

Init

Info

Photo

sensitivity

Normal

High

Low