Ekinex KONNECT4 설치 지침 - 페이지 3

{카테고리_이름} Ekinex KONNECT4에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Ekinex KONNECT4 4 페이지.

페이지 인쇄

Connection as IP gateway for Control4

KONNECT4 can be used as IP gateway for CONTROL4,

in order to make the COMPOSER PRO to communicate

with KNX devices.

This specific functionality does not require any configu-

ration in KONNECT4, and can be easily reached with a

standard KNX communication driver offered by Control4.

Configuration and commissioning

The configuration and commissioning of the Konnect4

server must be carried out by accessing the web server

integrated in the product. These activities must be carried

out in accordance with the design of the building automa-

tion system carried out by a qualified professional.

Network connection

The configuration and use of the Konnect4 server requi-

res a connection to the home or company network. The

default IP address of the delégo server is:

192.168.0.110

For the initial configuration of the server, as well as in

case of absence of a network during the installation pha-

se, it is necessary to proceed as follows:

• connect the server Konnect4 to your PC via a "cross

over" (or "crossover") network cable

• access your PC's network settings, as illustrated in

your operating system documentation

• Change the TCP/IP communication protocol settings

(version 4) for the LAN port of your PC, and set the

following parameters manually:

•

IP address: 192.16 8.0.100

•

Network mask: 255.255.255.0

•

Default gateway: 192.168.0.1

•

Save and wait for the new settings to take effect.

If prompted, reboot the system.

After these operations, open an Internet browser and type

in the address bar:

http://192.168.0.110

For an optimal browsing experience, we recommend

using one of the following browsers:

• Google Chrome

• Apple Safari

First access

When you open the browser at the default address, the

following login screen is displayed:

Konnect4 server has the following preset users at the

factory:

User

admin

user

Enter the credentials of the user "admin" and confirm to

access the main screen of the Konnect4 administration

environment.

Restore factory IP address

If necessary, you can restore the factory IP address of

the server Konnect4 using the RESET button available.

Follow the procedure below:

• open the front panel of the server Konnect4 using a

small slotted screwdriver, and exerting a slight leverage

effect in one of the side slots

• locate the RESET button on the back of the vertical

card

• press the button for at least 10 seconds until the SER-

VICE LED on the front of the device starts flashing,

then release the button

• within the next 5 seconds, press and release the button

for 1 second; within a couple of seconds the front LED

will light up solidly for a couple of seconds

• when the LED goes out, the device can be reached at

the factory IP address (192.168.0.110)

If the LED goes out after long press (10 seconds) before

short press, repeat the whole procedure. This procedure

resets the IP address and retains all data relating to the

configuration previously carried out on the automation sy-

stem.

Restore factory configuration

If the configuration made makes it impossible to access

the server Konnect4 or its correct use, it is possible to

restore the factory conditions, resetting the IP address

Password

Description

Automation system

administrator user.

He has the rights

admin

to create users,

manage their rights

and configure the

supervision

Basic user. It

has the rights to

view the system

status, navigate the

user

supervision pages

and perform basic

commands on the

automation system