Ekinex EK-E12-TP Series 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Ekinex EK-E12-TP Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ekinex EK-E12-TP Series 9 페이지. Pushbutton
Ekinex EK-E12-TP Series에 대해서도 마찬가지입니다: 데이터시트 (5 페이지)

페이지 인쇄

Warning! In order to supply the KNX bus lines use

only KNX bus power supplies (e.g. ekinex EK-AB1-

TP or EK-AG1-TP). The use of other power supplies

can compromise the communication and damage

the devices connected to the bus.

Configuration and commissioning

Configuration and commissioning of the device require

the use of the ETS

(Engineering Tool Software) program

V4 or later releases. These activities must be carried out

according to the design of the building automation system

done by a qualified planner.

Note. The configuration and commissioning of KNX

devices require specialized skills. To acquire these

skills, you should attend the workshops at KNX cer-

tified training centers.

Configuration

For the configuration of the device parameters the corre-

sponding application program or the whole ekinex

duct database must be loaded in the ETS program. For

detailed information on configuration options, refer to the

application manual of the device available on the website

www.ekinex.com.

Product

Application program

code

(## = release)

EK-E12-TP

APEKE12TP##.knxprod

EK-E22-TP

APEKE22TP##.knxprod

Commissioning

For commissioning the device the following activities are

required:

• make the electrical connections as described above;

• turn on the bus power supply;

• switch the device operation to the programming mode

by pressing the programming pushbutton located on

the front side of the housing. In this mode of operation,

the programming LED is turned on;

• download into the device the physical address and the

configuration with the ETS

At the end of the download the operation of the device

automatically returns to normal mode; in this mode the

programming LED is turned off. Now the bus device is

programmed and ready for use.

Reset of the device

To reset the device remove the bus connection by ex-

tracting the bus terminal from its seat. Keeping pressed

the programming pushbutton, reinsert the bus terminal in

his seat; the programming LED blinks fast. Release the

programming button and remove the bus terminal again;

the reset was carried out. Now you need to address and

configure again the device via ETS.

Warning! The reset restores the device back to the

state of delivery from the factory. The address and

the value of the parameters set during configuration

will be lost.

pro-

Communica-

Group

tion objects

adresses

(nr. max)

222

program.

Dimensions [mm]

Pushbutton for round wall box

Versions

for mounting with frame

for mounting without frame

Pushbutton for rectangular wall box

Versions

for mounting with frame

for mounting without frame

2,5

Dimensions L x H [mm]

81 x 77

80 x 80

Dimensions L x H [mm]

122 x 77

121 x 80

Rockers

2,5