American Standard Paradigm Selectronic 702B.1 Series 설치 지침 매뉴얼 - 페이지 7
{카테고리_이름} American Standard Paradigm Selectronic 702B.1 Series에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard Paradigm Selectronic 702B.1 Series 9 페이지. Integrated faucet with optional above-deck mixing & smartherm
페이지 인쇄
MAINTENANCE
HAND WASH SENSOR OPERATION;
A
Fig. 7
REMOVE PROTECTIVE FILM FROM SENSOR EYE WHEN
INSTALLATION IS COMPLETE.
When the Sensor detects a user, the water immediately starts
to flow. Water flow will stop 1.5 seconds after user is out of
sensor range. This Comfort delay allows the user to comfort-
ably move their hands without the water turning off.
As a precaution, a Safety Timer will turn off the water after the
sensor has been blocked for 59 seconds. The water will stay
off until the
blockage is removed from the detection zone.
The Comfort and Safety time settings can be adjusted using
the
Optional Remote Control (605XRCT).
REPLACE BATTERY; Fig. 8, 9
B
1. Remove 3 COVER SCREWS (1) and lift COVER (15) off.
2. Disconnect SENSOR CABLES (6) and (7) from the
BATTERY and SOLENOID VALVE. (Fig. 9)
3. Push BATTERY (17) forward and Pull it out. (Fig. 8)
4. Replace the new battery with the same placement.
(Insert terminal side first)
CHANGE SENSOR RANGE;
C
Fig. 8, 9
1. Remove 3 COVER SCREWS (1).
2. Remove the COVER (15).
3. Disconnect the BLACK POWER SUPPLY CONNECTOR (7)
and reconnect. Fig. 9.
4. While the SENSOR CONTROL LED (9) is blinking slowly,
place your hand 1 - 2 in. (25.4-50.8mm) in front of the sensor.
5. When the LED stops blinking and stays "ON" , move your hand
to the desired position and hold in place until the LED begins
to blink again.
6. Once the SENSOR CONTROL LED (9) begins to blink
again,
remove your hand from the detection zone. When the flashing
stops, the detection distance is set.
7. Reassemble the COVER (15) and secure it with COVER
SCREWS (1).
Fig. 7
Fig. 6
PROTECTIVE FILM
2
15
1
Fig. 8
Fig. 9
7
3
16
1
4
9
6
M965985 (11/18)
17
12
14
7