American Standard PINE 2011.101 설치 지침 - 페이지 2
{카테고리_이름} American Standard PINE 2011.101에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. American Standard PINE 2011.101 4 페이지. Monoblock bathroom sink faucet with conventional pop-up drain
페이지 인쇄
2
INSTALL POP-UP DRAIN
Fig.1
Apply a bead of putty to underside
of FLANGE (1).
Fig.2
Drop FLANGE (1) into LAVATORY DRAIN (2).
From below assemble RUBBER GASKET (3), METAL
WASHER (4) and LOCK NUT (5). Do not tighten.
Fig.3
Place SEAL (6) with small end facing up into
TAILPIECE (7) and tighten against DRAIN BODY (8).
PIVOT ROD (9) opening in TAILPIECE (7) should face
the rear of the lavatory.
Tighten LOCK NUT (10) with channel locks.
Do not over tighten.
3
ASSEMBLE PIVOT ROD TO POP-UP DRAIN
Assemble PIVOT ROD (1), PIVOT NUT (2), CLIP (3) and SEAL (4) as
shown. Hand tighten PIVOT NUT (2). Drop STOPPER (5) into drain.
(For vandal proof drain rotate stopper so PIVOT ROD (1) goes
through EYE (6) of STOPPER (5). Make connection to "P" TRAP .)
Remove one end of CLIP (3) from PIVOT ROD (1) by squeezing
ends together while sliding.
Insert PIVOT ROD (1) into second or third hole in EXTENSION (7)
and reassemble CLIP (3). (EXTENSION (7) may need to be bent).
Adjust STOPPER (5) height by repositioning EXTENSION (7) and
tightening THUMBSCREW (8).
Fig.1
1
PUTTY
Fig.3
8
9
8
7
3
Fig.2
3
10
6
7
5
1
2
4
1-1/4" OD
TAILPIECE
"P" TRAP
M965246 REV. 1.6
1
2
4
5
6