EKIZNSN F073 소유자 매뉴얼 - 페이지 11

{카테고리_이름} EKIZNSN F073에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. EKIZNSN F073 13 페이지. 20'' ceiling fan
EKIZNSN F073에 대해서도 마찬가지입니다: 소유자 매뉴얼 (13 페이지)

Troubleshooting

Please read all installation instructions carefully.

After reviewing the following tips, if you are unable to solve

a problem, please contact customer service for additional

assistance

Fan makes humming noise

• Be sure you are using the control set supplied with your fan

• Make sure all fittings are firmly secured. Loose parts will often

cause vibrational noise or humming. Removal and re-attachment

can sometimes remedy such resonant vibrational noise.

Fan not reponding to remote control

• Check that all wire connections are secure and made as instructed.

• Verify that power is on and reaching the receiver by a voltmeter.

• Verify that controller batteries are installed with proper polarity as

indicated inside the battery cover

Fan woobles

• Make sure the mounting plate and hardware at the ceiling are

secure and firmly fastened. If necessary, use the wood screws

provided to further secure the outlet box to the joist.

• Carefully lower motor housing and verify that the mounting plate is

secure to the outlet box, screws are tight.

Light does not work

• Check wire connections at ceiling and receiver.

• Confirm that LED wire leads and terminal block are properly

connected to the LED board.

Fan makes repetitive ticking noise

• Check for obstructions in the rotor path.

• Make sure mounting hardware at the ceiling is secure.

• Make sure all other hardware and blade attachments are tight.

• Give fan adequate "Break in Period" of several hours to several

days then repeat steps above.