Dongcheng S1M-FF03-115 사용 설명서 - 페이지 5
{카테고리_이름} Dongcheng S1M-FF03-115에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dongcheng S1M-FF03-115 6 페이지.
페이지 인쇄
lever. (Fig. 4)
Operation
Hold the tool firmly, turn the tool on and then apply the wheel or disc to the
workpiece.
In general, keep the edge of the wheel
or disc at an angle of about 15°-30° to
the workpiece surface.
During the break-in period with a new
wheel, do not work the grinder in the B
direction,
or
it
will
cut
into
workpiece. Once the edge of the wheel
has been rounded off by use, the wheel
may be worked in both A and B
directions. (Fig. 5)
WARNING:
It should never be necessary to force the tool. The weight of the tool applies
adequate pressure. Forcing and excessive pressure could cause dangerous
wheel breakage.
Continued use of a worn-out wheel may result in wheel explosion and serious
personal injury. Depressed center wheel should not be used after it has been
worn down to 75 mm (3") in diameter. Use of the wheel after this point is unsafe
and it should be removed from service and rendered unusable by intentional
destruction.
the
-7-
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and unplugged before attempting to
perform inspection or maintenance.
After use
Blow away dust from the inside of the tool by running the tool at an idle for a while.
Brush off accumulation of dust on the base.
Accumulation of dust in the motor or on the base may cause a malfunction of the tool.
Replacing carbon brushes
Remove and check the carbon brushes
regularly. Replace when they wear down to
the limit mark. Keep the carbon brushes
clean and free to slip in the holders. Both
carbon brushes should be replaced at the
same time. Use only identical carbon
brushes. (Fig. 6)
Use a screwdriver to remove the rear cover.
Disconnect the carbon brush from the brush
holder, then draw the Belleville spring and
take out the worn carbon bush and replace
new one; Release the Belleville spring and
reconnect each carbon brush with the brush
holder. And then tighten the rear cover
securely. (Fig. 7)
※Damaged cord must be replaced by a
special cord purchased from authorized service center.
※ To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed by authorized centers, always using original
replacement parts.
-8-