Dongcheng DJX03-255 사용 설명서 - 페이지 5

{카테고리_이름} Dongcheng DJX03-255에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dongcheng DJX03-255 14 페이지. Electric mitre saw

INSTRUCTIONS FOR OPERATION

CAUTION:

 Make sure that the tool is unplugged.

 Stopper pin is for carrying and storage purposes only and not for any cutting

operations.

Lower the handle fully and lock it in

the lowered position by pushing in the

stopper pin. Secure the turn base by

tightening the grip clockwise, then the

tool can be carried by carrying grip as

shown in Fig. 1.

The tool should be bolted with four

bolts to a level and stable surface

using the bolt holes provided in the

tool's base. This will help prevent

tipping and possible injury. (Fig. 2)

Installing or Removing Saw Blade

CAUTION:

 Always be sure that the tool is switched off and unplugged before installing or

removing the blade.

-7-

 Use only the provided socket wrench to install or remove the blade. Failure to do so

may result in overtightening or insufficient tightening of the hex bolt. This could cause

an injury.

 After installing a new blade, always be sure that the blade does not contact any part

of the lower base when the handle is lowered completely. Always do this with the tool

unplugged.

To remove the saw blade, turn lower

safety guard to exceed the position of the

screw firstly and loosen the screw holding

the lower safety guard. (Fig. 3)

Free the handle from the lowered position,

raise the blade guard and center cover.

Press the shaft lock to prevent the spindle

from revolving and use the socket wrench

to loosen the hex bolt. Then remove the

hex bolt, outer flange and the blade. (Fig.

To install the saw blade, mount it carefully

onto the spindle, making sure that the

direction of the arrow on the surface of the

blade matches the direction of the arrow

on the blade case. Install the outer flange

and hex bolt, and then use the socket

-8-