Dongcheng J1X-FF03-255 사용 설명서 - 페이지 3

{카테고리_이름} Dongcheng J1X-FF03-255에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dongcheng J1X-FF03-255 14 페이지. Electric mitre saw

페이지 인쇄

17. Do not force the power tool. Use the correct power tool for your

application. The correct power tool will do the job better and safer at the rate

for which it was designed.

18. Do not use tool if switch does not turn it on or off. Any power tool that

cannot be controlled with the switch is dangerous and must be repaired.

19. Disconnect the plug from the power source and/or the battery pack

from the power tool before making any adjustments, changing

accessories, or storing power tools. Such preventive safety measures

reduce the risk of starting the power tool accidentally.

20. Store idle power tools out of the reach of children and do not allow

persons unfamiliar with the power tool or these instructions to operate

the power tool. Power tools are dangerous in the hands of untrained users.

21. Maintain power tools. Check for misalignment or binding of moving

parts, breakage of parts and any other condition that may affect the

power tool's operation. If damaged, have the power tool repaired before

use. Many accidents are caused by poorly maintained power tools.

22. Keep cutting tools sharp and clean. Properly maintained cutting tools with

sharp cutting edges are less likely to bind and are easier to control.

23. Use the power tool, accessories and tool bits etc. in accordance with

these instructions, taking into account the working conditions and the

work to be performed. Use of the power tool for operations different from

those intended could result in a hazardous situation.

Service

24. Have your power tool serviced by a qualified repair person using only

identical replacement parts. This will ensure that the safety of the power

tool is maintained.

VOLTAGE WARNING:

Before connecting the machine to a power source (receptacle, outlet, etc.), be

sure the voltage supplied is the same as that specified on the nameplate of the

machine. A power source with voltage greater than that specified for the machine

can result in SERIOUS INJURY to the user, as well as damage to the machine. If

in doubt, DO NOT PLUG IN THE MACHINE. Using a power source with voltage

-3-

less than nameplate rating is harmful to the motor.

SPECIFICATIONS

Rated Power Input

No-Load Speed

Blade Diameter

Hole Diameter of Blade

Miter Angle

Max. Cutting

Bevel Angle

Capacity

0°

(H×W)

45° (Left)

Net Weight

※Due to the continuing program of research and development, the specifications

herein are subject to change without prior notice.

ADDITIONAL SAFETY RULES

1. Always wear eye protection to avoid injuries to eyes cased by the flying out

sawdust.

2. Do not operate this tool without guards in place. Check blade guard for proper

closing before each use. Do not operate miter saw if blade guard does not move

freely and close instantly. Never clamp or tie the blade guard at the open position.

3. Do not use the tool in the presence of flammable liquids or gases.

4. Check the blade carefully for cracks or damage before operation. Replace cracked

or damaged blade immediately. Gum and wood pitch hardened on blades slows

saw and increases potential for kickback. Keep blade clean by first removing it

from tool, and then cleaning it with gum and pitch remover, hot water or kerosene.

Never use gasoline to clean blade.

Use only flanges specified for this tool.

1650 W

6000 r/min

Ø255mm

Ø25.4 mm

45°

0°

(Left and Right)

60mm×130mm

60mm×93mm

45mm×130mm

45mm×93mm

12.0 Kg

-4-