Air Creation Pixel 200 지침 및 유지보수 핸드북 - 페이지 10

{카테고리_이름} Air Creation Pixel 200에 대한 지침 및 유지보수 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. Air Creation Pixel 200 16 페이지.

Every 50 hours of flight time:

Check the beam where the engine is mounted and around the upper beam rotation point for

cracks or play.

Check seams on welded assemblies and mounting holes for play (engine support, front forks,

lower beam, hang point, upper beam swivel joint, radiator mount etc.).

Grease throttle and brake cables and check cable stops; check condition and operation.

Every 100 flight hours:

Check throttle and brake cables, all screws involved in frequent mounting/demounting

operations (hang point, front strut, etc.), engine and propeller mounting screws.

Check tires, rims, wheel bearings, front fork and wheel axles.

Check engine mount, hang point, undercarriage struts and links, wheel shafts and seat seams.

Check upper and lower front strut connections for ovalization or cracks.

Check the condition of the manual starter rope.

In the event of heavy landings:

Check the front fork, remove and inspect the fork pivot and wheel shaft.

Check the seat frame and the lower beam for distortion. Check seat seams.

Check the upper beam and the front tube for straightness, the swivel joint (play, hairline cracks),

the engine and its rubber mounts.

Check the rear wheel assembly and assembly clearances.

If the sail has hit the ground, even slowly, have the wing disassembled and entirely

checked by a technical station or our factory.

ATTENTION:

Changing all Nylstop nuts after loosening is mandatory. Always secure such nuts using LOCTITE

glue.

GDMANPixel-1G

Tél. : 33 (0) 4 75 93 66 66 - Fax : 33 (0) 4 75 35 04 03 - Internet : www.aircreation.fr

AIR CREATION Aérodrome de Lanas - 07200 AUBENAS - France

Version 0010

PAGE : 10