ASTi SOUND+SLEEP SE 소유자 매뉴얼 - 페이지 8

{카테고리_이름} ASTi SOUND+SLEEP SE에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ASTi SOUND+SLEEP SE 12 페이지.
ASTi SOUND+SLEEP SE에 대해서도 마찬가지입니다: 소유자 매뉴얼 (11 페이지)

페이지 인쇄

1. How to Restore the Factory Settings

Technical Information

Specifications

SoundStories

Speaker Compensation

Headphone Jack

Audio Input Jack

USB-A Charging Ports

Power Requirements

"Off" Power Consumption

How to Restore the Factory Settings

(This sets the unit back to its original condition "fresh out of the box")

First turn unit Off. Then press the Power Button and hold it down until the

panel lights blink (about 5 seconds). It may make a small popping sound.

Trouble Shooting

If your Unit exhibits a problem, try the appropriate actions below.

SYMPTOM

No operation when

Power Button is

pressed.

Unit is On, but no

sound is heard.

Unit is On, but

volume is too low.

Volume is too high.

Other unexpected

behavior.

POSSIBLE CAUSE

Disconnected power

plug.

Unit is connected to a

switched wall outlet.

Faulty wall outlet.

System needs to be

reset.

Volume is set too low.

Cable plugged into

external audio input?

Headphones plugged

in?

Volume is set too low.

In Adaptive Mode?

Try the "factory reset"

procedure. If this

does not resolve the

issue, call Customer

Support.

5-band parametric EQ

3.5 mm stereo

2 Ports. 900 mA max (each)

5 Volts, 2.5 Amps DC

< 0.25 Watts (typically 0.1 Watts)

SOLUTION

Check the power connection on the

bottom of the unit and at the wall outlet.

Make sure that both are firmly seated.

Move the unit to an un-switched outlet.

Move to a working outlet and power on

again.

First power Off the unit, then press and

hold the Power Button for 5 seconds.

Press or hold the Volume Up Button to

increase volume.

Remove cable from Audio Input Jack,

or connect cable to audio source.

Remove headphones, speaker is muted

when headphones are connected.

Press or hold Volume Up Button to

increase volume.

In Adaptive Mode the sound will be low

when there is no noise in your room. If

you prefer it loud all time turn the

Adaptive Mode off.

Press or hold the Volume Down Button

to decrease volume to your liking.

1) Unplug power adapter from the AC

outlet

2) Press and hold the Power Button

down while plugging power adapter

back into AC outlet.

3) Continue to hold power button down

for 5 seconds.