Astin Trew AT 3000 운영 매뉴얼 - 페이지 8
{카테고리_이름} Astin Trew AT 3000에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Astin Trew AT 3000 13 페이지. Up-sampling with valve output amplifier
페이지 인쇄Point the remote at the facia panel
when using. It will work up to 10Mtrs.
from the CD Player and up to a 30
degrees either side of front panel.
The remote will also operate the
AT1000 pre-amplifier. The buttons
will not work with any other equip-
ment.
See illustration on page 6.
CD Player operation and
display features.
TURN ON:
When the power switch is pressed on,
the display screen will show 'READ'
then after a few seconds 'NO DISK'
or if a CD is in the draw, it will show
the number of tracks and total playing
time – example: '16-16 57:37'
UPSAMPLING:
Press 24bit/98khz button on facia or
remote to turn upsampling option on.
Orange LED will illuminate on facia
when in operation. With the upsam-
pling on, you should hear an improved
level of fidelity. Occasionally an upsam-
pled CD may sound harsh, have too
much high frequency energy or just
sound 'wrong'. Switch upsampling off
in this case to compare.
DISC PLAY:
Press open/close button on facia or
remote, screen display will show
'OPEN' and CD tray will open. Place
CD onto tray with printed side face up.
Press open/close button again, tray
will close and screen display will show
'READ' then number of tracks and
total playing time – example: '16-16
57:37'
When the number of tracks and total
time is shown, for example: '16-16
57:37' press play/pause button on
facia or
/II on remote and track
one will play, continuing on through all
tracks sequentially.
If the display then shows 'NO DISK'
the CD may have been put in upside
down, it may be too scratched or dirty
to read, or it may not be a compatible
CD ie. non compatible HDCD disk or
DVD. Most HDCD's are compatible
with CD players, check HDCD instruc-
tions on its disk cover.
It is rare but possible for condensation
to build on the laser lens to prevent its
operation if the unit has been moved
from a cold to a warm environment.
You may note condensation on the CD
Player casing as well. In this case,
wait for the CD player to warm up and
try again.
PAUSE:
Press play/pause button on facia or
/II on remote, display will show 'II'
graphic and stop. Press again and
the CD will continue.
7