Astivita ASTPYROV60 사용 설명서 - 페이지 15

{카테고리_이름} Astivita ASTPYROV60에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Astivita ASTPYROV60 19 페이지.

페이지 인쇄

Care and maintenance

Switching the appliance off

G B

Disconnect your appliance from the electricity

supply before carrying out any work on it.

Cleaning the appliance

The stainless steel or enamel-coated external

parts and the rubber seals may be cleaned using

a sponge that has been soaked in lukewarm water

and neutral soap. Use specialised products for

the removal of stubborn stains. After cleaning,

rinse and dry thoroughly. Do not use abrasive

powders or corrosive substances.

The inside of the oven should ideally be cleaned

after each use, while it is still lukewarm.

be cleaned by water directly ,but use wet towel

and detergent , then rinse well and dry with a soft

cloth. Do not use abrasive products.

All accessories can be washed like everyday

crockery, and are even dishwasher safe.

Never use steam cleaners or pressure cleaners on

the appliance.

Cleaning the oven door

Clean the glass part of the oven door using a

sponge and a non-abrasive cleaning product, then

dry thoroughly with a soft cloth. Do not use rough

abrasive material or sharp metal scrapers as these

could scratch the surface and cause the glass to

crack.

.or more thorough cleaning purposes, the oven door

may be removed:

1. Open the oven door fully (see diagram).

lift up and turn the small

levers . located on the two hinges (see diagram).

Can t

3. Grip the door on the two

outer sides and close it

approximately half way. Pull

the door towards you lifting it

out of its seat (see diagram).

To replace the door, reverse

this sequence.

Inspecting the seals

Check the door seals around the oven at regular

intervals. If the seals are damaged, please contact

your nearest After-sales Service Centre (see

Assistance). We recommend that the oven is not

used until the seals have been replaced.

Replacing the light bulb

To replace the oven light bulb:

Glass cover

3. Replace the glass cover (see diagram).

Do not touch the light bulb directly with your

hands.

Sliding rack kit assembly

To assemble the sliding racks:

Fig.1

Fig.2

Fig.3

1. Remove the

glass cover of the

Oven

lamp-holder.

compartment

2. Remove the

light bulb and

Lamp

replace it with a

similar one:

halogen lamp

voltage 230 V,

wattage 25 W,

cap G 9.

1. Remove the two frames, lifting them

away from the spacers A (See Fig.1)

2. Choose which shelf to use with the sliding

rack. Pay attention to the direction in which the

sliding tack is to be extracted, position joint B

and the joint C on the frame. (See Fig.2)

3. Secure the two frames with the guide rails

using the holes provided on the oven walls (see

diagram).The holes for the left frame are

situated at hole F1, F2 and the right frame at

hole D1,D2.

4. Finally, fit the frames on the spacers A.

5. Note:

The sliding rack is the optional

accessory.