Dongil Z Fire Series 사용자 설명서 - 페이지 7

{카테고리_이름} Dongil Z Fire Series에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Dongil Z Fire Series 10 페이지. Indirect air forced heater

페이지 인쇄

Do not leave the place with the heater turned on or plugged in.

Nozzle

Nozzle should be cleaned or replaced at least once a year. If contaminated

fuel is used, the nozzle should be replaced immediately. To clean the

nozzle, take it out from the burner, disassemble it, put it in the thinner or

gasoline for a while and carefully assemble it.

Ignition Plug

Ignition plug should be cleaned or the gap between the electrodes should be

adjusted every 600 hours or at any necessary time. Take it out from the

burner and clean it with steel brush. The gap between the electrodes should

be kept 3.5mm~3.7mm.

Photo-electric tube

Photo-electric tube should be cleaned once a year or at any necessary time.

Clean the photo-electric surface with some cotton cloth dipped in the water

or alcohol.

Photo-electric tube

Air bolwing Motor

Photo-electric tube holder

Air blowing Fan

Burner Head

Lgnition Plug

Support Piece

ZF-170ID

ZF-240ID

Diffusion

Nozzle

Burner head blade

Spark plug

ZF-80ID

Igniter

High pressure fuel hose

Nozzle

Ignition Plug

Distributor

Diffuser

Fitting Bolt

Burner head

Photocell

Blower fan

Blower motor

Indirect Air Forced Heater

Long-Time Storage

1. Open the fuel tank cap.

2. Remove the fuel with a bellow.

3. Clean the inside of the tank with some kerosene, gasoline or thinner.

Never use water at this time because rust may be fatal.

4. Dry the tank completely.

Never pass the season with the fuel in the tank. Old fuel may give damage

to the product.

Store the product at the dry and well-ventilated area.

Store the product at the place of no dust and moisture in the original

packing box.

Keep the user manual at the place close at hand.

First-Aid Measure

(Measure to the error codes displayed on the

temperature display window)

Display

Cause

Window

Power switch handling error

Power is supplied when

the switch is on.

Flame Detector (Photo-electric tube error)

1.Photo-electric tube defect

3.Incomplete Combustion

3.Contamination of photo-electric tube

4.Contamination of fuel filter

-Ignition trouble

1.Temperature sensor separation

2.Sensor Defect

Anti-overheating Sensor Defect

Unusual internal overheating

Shortage of Fuel

In case of below 9 C

Incase of over 50 C

Blinking

Electronic Circuit Board Defect

Measure

After plugging it out and turning

the switch off, plug it in and

turn on the switch.

1.Replacement of Photo-electric tube

2.Replacement to clean fuel

3.Cleaning of photo-electric tube

4.Cleaning of fuel filter

1.Checking the igniter wire

2.Cleaning or replacement

of ignition plug

Temperature sensor error

1.Re-connection of the sensor

Replacement of temperature sensor

-Re-operating after cooling

Float Sensor

Fuel Supply

Normal

1.Checking the circuit

2.Re-operating after reset