Donn Steward CPUville 8-bit 사용 설명서 - 페이지 9
{카테고리_이름} Donn Steward CPUville 8-bit에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Donn Steward CPUville 8-bit 14 페이지. Processor register display kit
페이지 인쇄Once you have checked the parts you can start to solder them onto the circuit board.
The easiest way to solder the components is to start with the shortest (parts that lie closest to the board)
and proceed to the tallest. The order is resistors, pushbutton switches, LEDs, IC sockets, capacitors, 4-
position DIP switch, 50-pin connector. The 16-pin receptacle is then soldered to the back.
Some components need to be oriented properly, as described below.
1. The resistors can be soldered first. They do not have to be oriented.
2. The pushbutton switches are next. The pins have a bend in them that should make them snap
into the holes before you solder them.
3. The LEDs are next. The cathode, which is side with the shorter lead, and the flat side of the
plastic base, is oriented toward the left. There is a small "K" on the circuit board symbol by the
cathode hole:
9