Astonica 50100182 사용 설명서 - 페이지 2
{카테고리_이름} Astonica 50100182에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Astonica 50100182 2 페이지. 26'' bistro table
페이지 인쇄PARTS & HARDWARE LIST
PART #
DESCRIPTION
A
Table Top
B
Leg Assembly
C
Wing Nut
A
Carefully remove the contents from the package. If any parts are missing do not attempt to
use the product until they have been obtained and correctly installed.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-424-3354.
QUANTITY
1
2
4
B
C
ASSEMBLY INSTRUCTIONS
Figure 1
C
C
1. Place table top (A) upside down on a non-scratching surface. (SEE FIGURE 1)
NOTE: One of the two leg assemblies center support is
positioned lower to allow the second to fit on top.
2. Locate leg assembly with lower center support. Place leg assembly (B) upside down and
align mounting holes over threaded studs on table top. Install wing nuts (C)
and finger tighten. Repeat for second leg assembly (B) and hand tighten wing nuts (C).
CAUTION: Do not over tighten fasteners.
3. All four legs should sit flat. If the table rocks, you have the leg assembly mounted in reverse
order. If so, repeat steps 1 - 3 reversing the placement order of the legs.
B
B
C
A
C