Astonica 50100218 사용 설명서 - 페이지 2

{카테고리_이름} Astonica 50100218에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Astonica 50100218 2 페이지. Table

PARTS & HARDWARE LIST

PART #

Table Top

Table leg

Leg Connector Ring

Screw, 15mm

Screw, 20mm

Flat Washer, 20mm

Hex Key

Table top

Table Leg

Carefully remove the contents from the package. If any parts are missing do not

attempt to use the product until they have been obtained and correctly installed.

IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,

DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT

1-888-422-7800.

CAUTION: Do not over tighten fasteners.

DESCRIPTION

table ring

QUANTITY

FIGURE 1

1. Unpack all parts and spread them out on a flat, non-scratching surface.

2. Place table top (A) upside down and attach legs (B) to threaded tabs of table.

Loosely fasten using flat washers (F) and screws (D).

3. Attach leg connect ring (C) to each leg (B). Table connector ring fits into

mounting slot off table legs. Loosely fasten using flat washers (F) and bolts (E).

4. Turn the table assembly right side up onto its legs.

5. Tighten all bolts securely using hex key (G). Turn bolts a few revolutions

at a time, alternating in a cross corner fashion.

ASSEMBLY INSTRUCTIONS