Donovan Hammer II 소유자 매뉴얼 - 페이지 6
{카테고리_이름} Donovan Hammer II에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Donovan Hammer II 20 페이지. Arm system for belly dumps, end dumps, dump bodies & pups
페이지 인쇄Front Drive - Through Cab Protector - continued
STEP 5: Insert stub shaft into end of tarp axle with drilled hole
and fasten with screw
L
STEP 6: Measure inside distance between side rails on cab
protector. Measure and mark tarp axle 1" shorter than
this distance (do not include stub shaft in measure-
ment). Cut squarely at mark and deburr cut end.
STEP 7:
Drill 5/16" hole 5/8" in from cut end of tarp axle, align-
ing hole as shown.
5/16"
drill
hole
STEP 8A: Electric system. Insert stub shaft through bearing
hole on passenger side of cab protector. Insert motor
shaft through hole on driver side and slide tarp axle
onto motor shaft. Fasten motor to cab protector with
supplied screws.
screws supplied
/
w
motor
cab protector
driver side
3
, washers
and nut
C
P
stub shaft
C
tarp axle
P
tarp axle
tarp axle
motor
shaft
STEP 8B: Manual system. Loosely assemble bearing to cab
protector using bolts
Insert stub shaft through bearing hole on passenger
.
L
side of cab protector. Insert sprocket shaft through
collar shaft and bearing into tarp axle.
STEP 9A: Electric system. Fasten tarp axle to motor shaft with
bolt
STEP 9B: Manual system. Fasten tarp axle to sprocket shaft
with screw
STEP 10A: Electric system. Slide flange bearing over stub shaft
and fasten to outside of cab protector with bolts
washers
G
motor
cover
collar shaft
passenger side
STEP 10B: Manual system. Follow instructions for electric
system in step 10A. On driver side, adjust sprocket
location as shown, then tighten all bearing fasteners
and set screws.
, washers
G
tarp axle
G
bearing
collar shaft
, washers
and nut
C
P
motor shaft
P
L
, washers
and nut
C
P
P
L
and nuts
. Tighten set bolts on bearing.
M
Q
stub shaft
bearing
Q
M
P/N 1809533 Rev. B
and nuts
.
Q
M
cab protector
Q
M
sprocket
.
L
C
P
tarp
axle
.
L
C
P
,
G
collar
shaft
bearing
2-1/4"
driver side
manual system