Astonica 50104036 사용 설명서 - 페이지 2
{카테고리_이름} Astonica 50104036에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Astonica 50104036 2 페이지. Lisbon 42'' patio table
페이지 인쇄PARTS & HARDWARE LIST
PART #
A
Table Top
B
Center Support Ring
C
Table Leg
D
Wing Nut
E
Nut
A
Carefully remove the contents from the package.
If any parts are missing do not attempt to use the product until they
have been obtained and correctly installed.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER, CONTACT CUSTOMER SERVICE AT
1-888-424-3354
FIGURE 1
B
E
DESCRIPTION
QUANTITY
B
C
D
E
.
FIGURE 2
A
C
1
General household tools will be needed for assembly.
2
4
1. Begin by mounting the legs (C) to the two center support rings (B)
4
with the nuts (E) (Figure 1).
8
2.
Holding one of the legs (C) and one support ring (B) together so that
the support ring threaded stud lines up with the hole in the tab
mounted on the leg. Slide the stud through the tab hole.
3.
Screw 1 nut (E) onto the bolt until hand-tight.
4.
Repeat steps 2 and 3 with the other support ring.
5.
Repeat steps 2 - 4 with the other three legs.
6.
At this point all four legs should be attached to the two center
support rings
7.
Place tabletop (A) upside down on a non-scratching surface such
as the table box, carpet, blanket or large towel (Figure 2).
8.
Turn the leg assembly upside down, and place the legs against
the tabletop (A) so that the four holes in the tops of the legs slide
onto the four threaded studs mounted underneath. Thread a
wing nut (D) onto each one, and tighten securely.
9.
Tighten each of the nuts (D) attaching the legs to the support rings
securely to ensure stability.
10. Have someone help you turn the table right side up.
D
ASSEMBLY INSTRUCTIONS