Astonica 50104288 사용 설명서 - 페이지 2
{카테고리_이름} Astonica 50104288에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Astonica 50104288 2 페이지. Flynn 40'' round dining table
페이지 인쇄PARTS & HARDWARE LIST
PART #
DESCRIPTION
A
Table Top
B
Upper Table Leg
C
Lower Table Leg
D
Bolt
E
Washer
F
Hex Key
Parts Detail
A
D
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
NOTE: This product is intended for residential, non-commercial use.
QUANTITY
B
C
E
F
1
CAUTION: Do not over tighten fasteners.
1
1
1. (SEE FIGURE 1) Place table top (A) upside
down on a non-scratching surface such as a
4
piece of carpet, blanket or large towel.
4
2. Turn the upper table leg (B) upside down so
1
that the holes at the top of the legs line up with
the holes underneath the table top (A). Then
do the same with the lower table leg (C). The
center support holes should fit flush together.
3. (SEE FIGURE 2) Secure each leg (B,C) to the
table top (A) using washer (E) and bolt (D).
4. (SEE FIGURE 3) Turn the table right side up.
5. All four legs should sit flat. If the table rocks,
the table legs have been mounted in reverse
order. If so, repeat steps 1 - 3 reversing the
placement order of the table legs.
ASSEMBLY INSTRUCTIONS
Figure 1
C
Figure 2
D
E
Figure 3
B
A