Astonica 50105067 사용 설명서 - 페이지 2

{카테고리_이름} Astonica 50105067에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Astonica 50105067 2 페이지. Round patio table

페이지 인쇄
Astonica 50105067 사용 설명서
ASSEMBLY INSTRUCTIONS AND CONTENTS
TABLE ASSEMBLY PARTS LIST
1
Table Rim
1
Tempered Glass Top
4
Table Legs
1
Leg Connector Ring
12 Plastic Bolt Cap
8
M6x28mm Bolts
4
M6x15mm Bolts
4
Flat Washers
1
Angled Hex Driver
1
Plastic Umbrella Hole Cap
(A)
(B)
(C)
(D)
(E)
(F)
(G)
(H)
(I)
(J)
Carefully remove the contents from the package.
If any parts are missing do not attempt to use this product until they have been obtained and correctly installed.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER, CONTACT CUSTOMER SERVICE AT
1-888-422-7800
(A)
(B)
(C)
(D)
(E)
(F)
(G)
(H)
(I)
(J)
.
2
(Figure 2)
Assembly Instructions
(Figure 2)
1.
Unpack all parts and spread them out on a flat, non-scratching surface.
2.
Turn Table Rim (A) upside down.
3.
Insert the 4 Table Legs (C) into the slots in the edge of the Table Rim(A). Thread
an M6x15mm (G) Bolt and Flat Washer (H) into each Leg (C) to secure them in
place.
4.
Attach each Leg (C) to the Leg Connector Ring (D) with the 8 M6x28mm
Bolts (F).
5.
Turn the table frame assembly right side up onto its legs.
6.
Tighten all bolts (F) and (G) securely with the Angled Hex Driver (I).
7.
Place plastic bolt caps (E) over each of the bolts.
8.
Carefully slide the Glass Top (B) into place. The smooth side should be facing
up. Insert the Plastic Umbrella Hole Cap (J) into the umbrella hole.
3