Astonica 50105073 조립 지침 - 페이지 3
{카테고리_이름} Astonica 50105073에 대한 조립 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Astonica 50105073 3 페이지. Tosca serving bar
페이지 인쇄ASSEMBLY INSTRUCTIONS
1. (See Figure 1) Lay the table top (A) face down on
a flat non-scratch surface. Position support bar (E)
between holes in table top and secure with
screws (J).
2. (See Figure 2) Position leg (B) between holes in
the narrow end of table top (A) so that the arrows
on the leg and table top point in the same
direction and secure with screws (J).
3. (See Figure 3) Attach leg (C) to the table top by
pushing one end then the other into the clamps
located under the wide end of table top (A). Make
sure the arrows on the leg and table top point in
the same direction. Secure to table top center
brace with screw (J).
Figure 1
J
J
E
A
Figure 2
B
A
J
Figure 3
C
A
J
2
4. (See Figure 4) Connect leg (D) to leg (C) with
screws (K). Tighten all fasteners and with the
help of another person, carefully turn the bar
upright.
5. (See Figure 5) Attach foot rest bar (G) to legs (B),
(C) and (D) with screws (K).
J
6. (See Figure 6) Maneuver one of the mesh
shelves (F) between the vertical bars of legs (B),
(C) and (D), angle upwards, and lay it flat across
the lower horizontal bars. Align holes, and secure
shelf to legs with screws (L), washers (N) and
nuts (M). Repeat this process for the upper shelf.
7. (See Figure 6) Attach bottom fabric bar (I) to legs
between foot rest and mesh screen and secure
by pushing it into plastic clamps on legs (C) and
(D). Secure the ends of fabric bar (I) to legs (B)
and (C) with screws (K).
Figure 4
D
K
C
K
Figure 5
K
D
C
K
G
K
Figure 6
F
I
3