Astonica 50105364 사용 설명서 - 페이지 2
{카테고리_이름} Astonica 50105364에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Astonica 50105364 2 페이지. Wicker & iron bistro table
페이지 인쇄
PARTS & HARDWARE LIST
PART #
A
Table top
B
Legs
C
Small Support Ring
D
Large Support Ring
E
Bolts 6mm x 30
F
Hex Nuts 6mm
Parts Detail
A
C
E
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-424-3354.
NOTE: This product is intended for residential, non-commercial use.
DESCRIPTION
B
D
F
1
QUANTITY
Caution: Do not over tighten fasteners.
1
4
1. (SEE FIGURE 1) Place the table top (A)
upside down on a non-scratching surface.
1
1
16
16
2. (SEE FIGURE 2) Insert each leg (B) into
the plastic sleeves located underneath
the table top (A).
3. (SEE FIGURE 3) Insert small support
ring (C) between legs (B) near the
table top (A).
Attach support ring to one leg (B)
with bolts (E) and secure using
hex nuts (F).
Repeat this with the other three legs.
NOTE: Do not completely tighten bolts.
4. (SEE FIGURE 3) Attach large support
ring (D) near the bottom of the legs (B),
in the same manner as Step 3.
NOTE: Do not completely tighten bolts.
5. (SEE FIGURE 4) Turn table assembly
right side up on a level surface, then
tighten the bolts (D).
ASSEMBLY INSTRUCTIONS
Figure 1
A
Figure 2
A
Figure 3
B
A
Figure 4
2
B
E
D
F
E
C
E
F