Astonica Montica 사용 설명서 - 페이지 2
{카테고리_이름} Astonica Montica에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Astonica Montica 2 페이지. 42'' round table
페이지 인쇄
PARTS & HARDWARE LIST
PART #
DESCRIPTION
A
Table Top Tempered Glass
B
Table Legs
C
Leg Connector Ring
D
Plastic Umbrella Ring
Flat Head Socket Cap (Screw)
E
F
Bumper, Clear Plastic
G
Hex Key
A
C
D
Carefully remove the contents from the package. If any parts are missing do not
attempt to use the product until they have been obtained and correctly installed.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,
DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT
1-888-424-3354.
CAUTION: Do not over tighten fasteners.
QUANTITY
1
4
2
1
8
4
1
B
E
F
G
ASSEMBLY INSTRUCTIONS
FIGURE 1
Step 4
A
1. (SEE FIGURE 1) Place the table top (A) upside down on a flat non-scratch surface.
2. Insert bumpers (F) into table legs (B). Position bumpers between table top
and table legs.
3.
Locate end cap leg fittings underneath the table top rim.
4. Inset table legs (B) into end cap leg fittings of table top (A).
5. Place leg connector rings (C) between table legs (B) and secure with flat head
screws (E). Finger tighten only.
6. Carefully rotate table assemble to upright position.
7. Tighten screws (E) with hex key (G) in a cross corner "X" fashion.
8. Install plastic umbrella ring (D).
B
C
E
F