Astonica 40201031 사용 설명서 - 페이지 3

{카테고리_이름} Astonica 40201031에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Astonica 40201031 3 페이지. Antique wood water-wheel fountain

페이지 인쇄

PARTS LIST

PART #

Fountain Pump

Hand Pump

Water Wheel

Fountain Tub

Pump Stem

Pump Platform

Water Wheel Bracket

Bolt

Wood Screw

Parts Detail

Carefully remove the contents from the package. If any parts are missing do not

attempt to use the product until they have been obtained and correctly installed.

IF YOU HAVE ANY PROBLEMS OR QUESTIONS CONCERNING THIS PRODUCT,

DO NOT RETURN IT TO YOUR RETAILER. CONTACT CUSTOMER SERVICE AT

1-888-424-3354

ASSEMBLY INSTRUCTIONS

CAUTION: Do not over tighten fasteners

Install Water Pump

1. (SEE FIGURE 1) Place fountain pump (A) inside fountain tub (D) as shown.

NOTE: The water flow speed can be adjusted at this time. Further adjustments may be

necessary once water fountain has been assembled and tested.

Adjust Speed of Water Flow

1. Turn adjustment lever on pump (A) towards "--" or "min" to decrease water flow, or away

from "--" or "min" to increase water flow.

Build Water Fountain

1. (SEE FIGURE 1) Align pump platform (F) with mounting holes at top of fountain tub (D).

2. Attach pump stem (E) to bottom of hand pump (B). Insert pump stem through mounting hole at

top of pump platform (F).

3. Insert pump stem from hand pump (B) into top of fountain pump (A). Secure pump platform (F)

to fountain tub (D) using four wood screws (J). Do not over tighten fasteners.

4. Mount water wheel brackets (G) to inside of fountain tub (D) as shown. Secure using two bolts

(H) for each bracket.

5. Place water wheel (C) rods on top of water wheel brackets (G).

DESCRIPTION

Figure 1

QUANTITY

Fill Fountain with Water

NOTE: Do not plug in the pump before filling basin with water. Running the pump without

water may damage pump.

1. Fill fountain tub (D) with water.

2. Plug power cord from pump into properly grounded 120V AC outlet.

3. Water should start to flow from basin to top of fountain. See section entitled

"Maintenance" if water is not flowing.

Maintenance

CAUTION: Never allow pump to run without water.

1. Check water level periodically, add water when necessary.

2. If water is not flowing, check pump (A), pump stem (E) and for clogs.

3. Verify pump is properly connected to pump stem (E), see section entitled "Install Pump" for

detailed instructions.

NOTE: Pump may build up calcium after a long period of time and stop running when tap

water is used. Any calcium remover can be used to clean pump.