AmeriGlide Stair Lift 설치 매뉴얼 - 페이지 14

{카테고리_이름} AmeriGlide Stair Lift에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AmeriGlide Stair Lift 15 페이지. Stair lift

I N S T A L L I N G

To install the upper limit cam, run the lift down about 1 foot by

using the control on the armrest.

2 Locate the upper limit cam and move to the top of

the track – position it approximately ½" from top

track cover and tighten into place.

3 Final Limit Switch Actuator

In the event that the lift over travels or

is moved up past the normal upper stop

position, the lift will push the final limit

actuator up into the final limit switch

disabling the unit. In order to return the lift to operation, you must manually

hand crank the lift down the track a few inches, and then slide the final limit

actuator down approximately one inch by tapping on it.

I N S T A L L I N G

T H E

upper call

control box

lower call

control box

U P P E R

L I M I T

C A L L

C O N T R O L S

Finish routing the call control

wire into the upper track channel

on the wall side of the track. Plug

into one of the two call control

connectors.

Plug in the upper call control box

to a call control connector.

Plug in the lower call control box

to the call control connector at

the bottom of the track.

NOTE: Call controls can be

mounted to the floor so they can

be operated by your foot, or

placed on the wall and operated

by hand.

Run the unit down to a few

inches past the lowest track

splice.

C A M