AmeriGlide PR458 Series 소유자 매뉴얼 - 페이지 6
{카테고리_이름} AmeriGlide PR458 Series에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AmeriGlide PR458 Series 12 페이지.
페이지 인쇄INSTALLATION FOR YOUR POWER LIFT CHAIR
1. Remove the transformer from the transformer box (located behind the lower
outside back). Place two 9 volt alkaline batteries into slots provided as shown.
Place transformer on floor behind the chair.
2. Plug the transformer into a 115-120V 60Hz A.C. outlet and connect the power
cable from the chair into the transformer as shown. Power cable is located under
the chair attached to the motor with white zip tie. Remove zip tie, extend the
cable under and out behind the chair.
Plug
To outlet
115-120V A.C.
3. Place the chair in the desired position in the room, keeping it 18" away from
the wall. If placing the chair into a corner, keep it 18" from the wall as shown.
Distance Required From
Wall When Reclined
Model Number
PR458-SMA
PR458-S23
PR458-MED
PR458-M23
PR458-LAR
4. Adjust the leg levelers on the bottom of the chair if necessary to level the chair.
Some high pile carpets can obstruct the footrest operation by rubbing against
it. Adjust the levelers to a height above the pile.
5. Slide the hand control from between the back and arm out toward the back of
the chair. Secure the cord into the quick release cable clamp located above the
magazine pocket on the arm of the chair.
L.E.D. light
DC Power
Transformer
Wall
Corner
17 in.
17 in.
17 in.
17 in.
17 in.
17 in.
17 in.
17 in.
18 in.
18 in.
Bottom view of
L.E.D. light
From motor
18"
Side
View
6
Transformer
Install two 9 volt batteries
in transformer for battery
backup (See page 8)
(batteries not included)
18"
Corner
Top
View
18"