Astonica 50104147 사용 설명서 - 페이지 4

{카테고리_이름} Astonica 50104147에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Astonica 50104147 4 페이지. Civello gazebo

ASSEMBLY INSTRUCTIONS

1. (Figure 1) Assemble the four corner uprights of

the gazebo by attaching upright panels (A) and (B)

as shown using screw, washer and nut sets (G).

Slide the plastic nut cover over nut after

tightening. Place the assembled uprights at each

corner of an approximately 10" square area in a

flat and level location.

CAUTION Do not over tighten fasteners.

An additional 1/4 turn to 1/2 turn more after

joint becomes snug is adequate.

Overtightening can collapse the frame tubing.

2. (Figure 2) Build the four side pole assemblies by

attaching two side poles (E) to the side pole

connector brackets (N) with screw, nut & cap

sets (I).

3. (Figure 3) Place assembled side pole sections on

top of corner uprights and secure with fastener

sets (J).

NOTE: Angled side bracket of side pole

connector brackets (N) should be facing

up and into the center of the gazebo.

FIGURE 1

FIGURE 2

FIGURE 3

4. (Figure 4) Align Corner roof brackets (L) in the

corners of uprights on top of pole sections and

secure with screw, nut & cap sets (F).

5. (Figure 5) Attach corner roof rails (C) to tabs of

roof bracket (K) as shown using screw, nut & cap

sets (H).

Attach side roof rails (D) to tabs of roof

bracket (K) as shown using screw, nut and cap

sets (H).

6. (Figure 6) Lift roof assembly into position and

attach corner roof rails (C) to corner roof brackets

(L) with screw, nut & cap sets (H). Attach side roof

rails (D) to side pole connector brackets (N) with

fastener sets (H).

FIGURE 4

FIGURE 5

C or D

FIGURE 6