Astor-Bannerman ABW6SP 사용 설명서 및 설치 설명서 - 페이지 7
{카테고리_이름} Astor-Bannerman ABW6SP에 대한 사용 설명서 및 설치 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Astor-Bannerman ABW6SP 12 페이지. Height adjustable basin
페이지 인쇄•
Switch on the mains voltage, a light fitted next to the
Handset socket on the right hand side of the unit,
should be illuminated.
Test the Safety Switch mechanism on the arms
•
Operate the lowering function and then lift the right
hand arm to ensure the motor cuts out.
•
Leave the mains voltage supply switched on as it will
allow the batteries to charge.
•
Remove the 'P' Trap & straight coupling from the waste
assembly.
•
Fit the waste and cable tie in position as shown.
Assemble the Basin:
•
Cover the support arms to protect the Basin.
•
Rotate the support arms so they are horizontal and place the up turned basin on the arms.
•
Fit the tap bodies to the basin as shown. Ensure there is 35mm of threaded body showing above
the basin deck to allow fitting the handle. Ensure the nylon washer is fitted under the handle
screw to remove any clearance on the spline.
•
•
Fit the 1/"-15mm tap adaptors
•
Fit the spout in position and connect the flexible hoses as shown.
•
Fit the overflow, hose and waste connection into the basin, apply a thin film of silicon sealant to
the faces to assist with sealing
•
Using the adjusting screw, set the overall length of the basin plug to 77mm.(may need adjusting
later)
Fit the plug operating actuator.
•
Attach the mounting bracket using screws.
•
Stand the lower cover in place, then:-
•
Fit the horizontal plug lifting rod in position and set the clamp to lift the plug. See measurements.
works properly.
Page: 7
Version : 11-04-016