Door Controls DC-ONE V3 시작하기 및 문제 해결 매뉴얼 - 페이지 4

{카테고리_이름} Door Controls DC-ONE V3에 대한 시작하기 및 문제 해결 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Door Controls DC-ONE V3 13 페이지. Automatic door controller

 OPEN DECELERATION

open location, the motor is decelerated to halt motion. This

parameter controls the length of time for DECELERATION. this

is for HEAVY DOORS only. leave this set to default. If you need

to add some deceleration, Raising this value will increase

deceleration "ON" time (Not the amount of deceleration)

 CLOSE DECELERATION

close location, the motor is decelerated to halt motion. This

parameter controls the length of time for DECELERATION this is

for HEAVY DOORS only, leave this set to default. If you need to

add some deceleration, Raising this value will increase

deceleration "ON" time (Not the amount of deceleration)

 OPEN TORQUE

move the door throughout the entire open cycle. If the door will

not open properly or moves to slow. This is where to start. Turn

this up 10% at a time till the door moves through the cycle without

hesitation.

 CLOSE TORQUE This is where we set the controller power to

move the door throughout the entire close cycle. If the door will

not close properly or moves to slow. This is where to start. Turn

this up 10% at a time till the door moves through the cycle without

hesitation.

 OPEN CHECK TORQUE

power to move the door throughout the open check cycle. If the

door will not open completely. This is where to start. Turn this up

10% at a time till the door moves through the cycle without

hesitation.

 CLOSE CHECK TORQUE

power to move the door throughout the close check cycle. If the

door will not close completely. This is where to start. Turn this up

10% at a time till the door moves through the cycle without

 OPEN CHECK SIZE **

Open Speed to Check Speed. (inches from full open position)

 CLOSE CHECK SIZE **

from Close Speed to Check Speed. (inches from full closed

position)

 REDUCE OPEN SIZE **

Partial Open is selected on Multifunction Switch and an

Activation signal is received.

When the door reaches the check

This is where we set the controller power to

This is where we set the controller

This is where the door transitions from

This is where the door transitions

Door will only open to this setting if