DAB ACTIVE DRIVER M/T 1.0 프로그래밍 매뉴얼 - 페이지 7

{카테고리_이름} DAB ACTIVE DRIVER M/T 1.0에 대한 프로그래밍 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DAB ACTIVE DRIVER M/T 1.0 10 페이지.

Ad>INTERCONNECTION ADDRESS

given to each of the ACTIVE DRIVER units when they are connected in a multiple pump

system. A cable connection needs to be made in order to achieve this condition. (Not

applicable to the AD M/M 1.1)

To access this setting, press [mode], [set] and [-] simultaneously for five seconds,

press [mode] until the display indicates

default setting and is used when the unit is operating as a

STAND ALONE system. This condition can be changed by altering this parameter to

0.1

for Pump 1,

Once the setting has been made, pressing the [mode] key will move the display to the

next settable parameter, pressing [set] will return the indication to the operating mode

of the system (Go or Sb)

Eb>ENABLING THE BOOSTER

on in a multiple pumps system. (Not applicable to the AD M/M 1.1)

To access this setting, press [mode], [set] and [-] simultaneously for five seconds,

press [mode] until the display indicates

default setting. This condition can be changed by altering this parameter to

will identify the order in which the pumps will start.

Once the setting has been made, pressing the [mode] key will move the display to the

next settable parameter, pressing [set] will return the indication to the operating mode

of the system (Go or Sb)

These are the main parameters that need to be set by the installer.

The system is now ready for operation. Ensure there is not an open flow condition

present, as this will make the AD device ineffectual.

Programming > Resetting Error Conditions

For some malfunctions and shutdowns the AD makes a certain number of attempts to

automatically reset the system.

0.2

for Pump 2 etc.

, refers to the name

_._

, and then flashes to

, turn the alternating function

, and then flashes to

which is the

. This