Door Knox VDP103 매뉴얼 - 페이지 8

{카테고리_이름} Door Knox VDP103에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Door Knox VDP103 15 페이지.

VDP103

2.7.2

Deleting using the Delete Card

Swipe the master card or fob 3 times within 10 seconds (2 beeps, 2 beeps, 3beeps). The

name panel will flash slowly.

Swipe the card or fob that you wish to delete (double beep). Keep swiping cards or fobs until

you have finished deleting.

To exit deleting mode swipe the master card again(single beep) or wait for 1 minute.

To delete all cards at the same time see

2.7.3

In admin mode:-

Press 288# (7 rapid beeps)

4 beeps indicates that it has failed.

2.8

There are three unlock modes card or fob only, card or fob or user PIN, card or fob and user

PIN.

In admin mode:-

Card or fob mode - press 300# (double beep)

Card, fob or user PIN - press 301# (double beep)

Card, fob and user PIN - press 302# (double beep)

Note: The Entry PIN, and the Add or Delete cards or fobs will allow access whatever the

unlock mode is set to.

2.9

In admin mode:-

Press 4nn# (double beep).

Or In admin mode press 400# to enter toggle mode i.e. swipe the card to unlock and then

swipe the card again to lock.

Note: nn = Time in seconds between 01-99.

Safe mode has 3 settings. Off, Lock and Alarm.

If set to Lock then scanning unprogrammed cards or entering an incorrect PIN 10 times in 5

minutes will lock the unit for 1 minute and will automatically call the monitor.

Deleting All Cards and Fobs