Door-Gard Wiegand 272i 프로그래밍 및 사용 지침 - 페이지 4
{카테고리_이름} Door-Gard Wiegand 272i에 대한 프로그래밍 및 사용 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Door-Gard Wiegand 272i 4 페이지. Wiegand 272 series
페이지 인쇄272mp
SW1
+
-
DA0 DA1 LD1 LD2
272i
+
-
DA0 DA1 LD1 LD2
272wp
Bi-color
LED
red
black
+
-
DA0 DA1 LD1 LD2
Current Draw
@ 5VDC - 13.2ma MAX
@12VDC- 38.2ma MAX
272MP- No backlighting if
Weigand panel power out-
puts 5v to Weigand read-
er. A separate (12vdc)
supply will be needed with
a common ground
between keypad and
Weigand panel.
P1- On = Backlit enabled
(12vdc only)
Off = Backlit disabled
P1
To
Control
Panel
Current Draw
@ 5VDC - 4.6ma MAX
@12VDC- 11.4ma MAX
SW1
r
red LED
b
r
green LED
b
r
yellow LED
b
To
Control
Panel
SOUNDER
red
SW1
black
Current Draw
@ 5VDC - 9.9ma MAX
@12VDC- 16.9ma MAX
To
Control
Panel
BASIC WIEGAND CONTROL PANEL
+
DA0
DA1
LED
272xt
red
black
P1
white\yellow
black\white
SW1
If LED does not change states, a " pull-up "
resistor may be required. Using a 10kΩ Ω ¼w
resistor, connect one end to V+ and the other end
to Led @ the control panel.
If this product does not seem to operate properly, please call
our Technical Department toll free at 1-800-343- 9502 (781-821-5566)
Monday -Friday 8:00 am-7:00 pm EST.
We understand your time is valuble, and we know that calling
our Technical Support Department will ensure that you'll make the most
profit possible with your IEI product. Thank you for your purchase. We
appreciate your business.
International Electronics,Inc.(IEI) warrants its products to be free
from defects in material and workmanship, when they have been installed in
accordance with the manufacturer's instructions, and have not been modified
or tampered with. IEI does not assume any responsibility for damage or
injury to person or property due to improper care, storage handling, abuse,
misuse, normal wear and tear, or an act of God.
IEI's sole responsibility is limited to the repair (at IEI's option) the
replacement of the defective product or part when sent to IEI's facility (freight
and insurance charges prepaid), after obtaining IEI's Return Merchandise
Authorization. IEI will not be liable to the purchaser or any one else for inci-
dental or consequential damages arising from any defect in, or malfunction
of, it's products.
This warranty shall expire two years after shipping date for
DOOR-GARD keypads. Except as stated above, IEI makes no warranties,
either express or implied, as to any matter whatsoever, including, without
limitation to, the condition of its products, their merchantability, or fitness for
any particular.
P2
+
DA0
DA1
LED
To
Control
Panel