Ameritrax D.W. Boogity Grill Classic Racer 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Ameritrax D.W. Boogity Grill Classic Racer에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Ameritrax D.W. Boogity Grill Classic Racer 13 페이지. Portable barbecue & stove

페이지 인쇄

ASSEMBLY INSTRUCTIONS

Step 1.

BOTTOM TRAY SET UP:

Unfold wire Legs mounted on the

BOTTOM TRAY to the open position and

place on a level non-flammable surface.

Step 2.

BODY INSTALLATION:

Unfold Hinged GRILL BODY. With the vent

holes in the down position, fit GRILL BODY into

the BOTTOM TRAY, placing notches over Wire Legs.

If necessary, adjust Wire Legs to accommodate

notches on GRILL BODY. Make sure that there

is a level secure fit.

FOR USE AS A CHARCOAL OR WOOD BARBECUE

Step 3.

FUEL TRAY RACK INSTALLATION:

Hold FUEL TRAY RACK in upright position.

Insert FUEL TRAY RACK into Body at a 45-degree

angle, through the LOWEST level of the END WALL

slot so that the FUEL TRAY RACK rests securely

on the edge of the END WALL. Lower the opposite

end of the FUEL TRAY RACK and slide it into place

over the opposing LOWEST level END WALL slot.

Make sure the FUEL TRAY RACK fit is secure.

Step 4.

FUEL TRAY PLATE INSTALLATION:

With the vent flaps placed in the upward position.

Insert the FUEL TRAY PLATE on top of the FUEL TRAY RACK.

Press down gently to insure a snug fit.

Step 5.

CHARCOAL INSTALLATION:

Place charcoal briquettes on FUEL TRAY. Use only enough charcoal to cover FUEL TRAY one layer thick, at

maximum. Overloading the FUEL TRAY may cause damage to entire Grill. (For further information see Lighting

Instructions).

Step 6.

COOKING GRATE:

Install COOKING GRATE.