AMERITRON AL-80A 사용 설명서 - 페이지 4

{카테고리_이름} AMERITRON AL-80A에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. AMERITRON AL-80A 12 페이지. High power linear amplifier
AMERITRON AL-80A에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지), 사용 설명서 (7 페이지), 사용 설명서 (6 페이지)

페이지 인쇄

POWER

OPERATE-

SWITCH

STANDBY

SWITCH

TUNING INSTRUCTIONS

Follow the instructions in numerical order. If the various meter readings are different than indicated in the instructions,

check the connections from the exciter to the amplifier and make sure they are correct. Consult the manual for the

exciter if necessary.

1. Set the AL-80A front panel switches as follows:

PWR - OFF to OFF

OPR - STBY to STBY

MULTIMETER to HV

2. Plug the A.C. line cord into the proper voltage outlet. The AL-80A is factory wired for 117VAC 50/60 Hz operation.

3. Set the PWR-OFF switch to PWR. The meter lamps should light and the blower should start. Read the 0-3500V

scale on the multimeter. It should indicate 3100 volts nominal.

With the

amplifier still on standby, tune the exciter into the normal 50 ohm load according to the manufacturer's

instructions. Turn the exciter drive fully down after tuning.

5. Place the bandswitch on the same band as the exciter, the PLATE tuning control in the dial range for the band

selected and the LOAD control at the recommended point for the band in use.

6. With the exciter drive still at zero, place the MULTIMETER switch in the Ip position. Observe the 0-700

scale.

It should read zero. Place the STBY-OPR switch in the OPR position.