AMERITRON AL-811H 소유자 매뉴얼 - 페이지 12

{카테고리_이름} AMERITRON AL-811H에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AMERITRON AL-811H 19 페이지. Hf power linear amplifier
AMERITRON AL-811H에 대해서도 마찬가지입니다: 사용 설명서 (12 페이지), 포장 풀기 사용 설명서 (11 페이지), 매뉴얼 (13 페이지)

페이지 인쇄
AMERITRON AL-811H 소유자 매뉴얼
(Fig. 16)
Flip the unit carefully on its side and remove the following screws:
(Fig. 17)
Lay amplifier down and maneuver tube chassis to reach all sockets. Depending on wiring, the filament leads or
red HV choke lead could require removal. The filament leads are supposed to be loosely twisted as the photo
shows. Fig 18. The optional 200 ohm 25 watt resistor requires drilling a #4 clearance hole, deburring the hole,
and using heatsink compound and proper hardware (6x32 bolt with the lockwasher and a nut on it) to mount
the resistor. The resistor connects across the neutralizing capacitor. Fig. 18 Lead lengths are not especially
critical. Ground the tube grids directly using solder lugs provided in the kit and solder the GDT's in as shown in
Fig. 18.
(Fig. 18)