DoorHan SECTIONAL-1000PRO-CE 설치 및 운영 매뉴얼 - 페이지 12
{카테고리_이름} DoorHan SECTIONAL-1000PRO-CE에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorHan SECTIONAL-1000PRO-CE 20 페이지.
페이지 인쇄
4. Ventilation (Partial opening)
Record remote button to control the partial opening of the door.
Pressing «+» and «-», set the value of the function «Y». Confirm your selection by pressing the «P» button.
After pressing the «P» button, the operator automatically switches to the recording mode of the control button.
Press «+»
«4» will light, press «Р»
NOTE: In the absence of control commands, the program exits transmitter recording mode automatically in 20 sec. Setting of
the door lifting height see Section 6.5, p. 5.
5. Safety devices
Press «+»
NOTE: Activate this function if you use safety devices.
6. Reverse of the carriage when the door is closed
Press «+»
Reverse of the carriage reduces the load on the chain allowing you to effortlessly unhook the door (to switch to the manual
mode).
7. Automatic door closing
Нажмите «+» —
Press «Р»
загорится «7»
8. Reset to factory settings
+
-
P
Press «+»
When the parameters are reset to the factory settings, the range of door movement, as well as the remotes recorded in
memory are not reset.
12
Pressing «+» or «-» choose the function value: «Y» — on,
«n» — off, (factory setting — «n»)
«5» will light, press «Р»
«6» will light, press «Р»
+
-
P
Press «+», «7» will light
Pressing «+» or «-» choose the function value: «0» — off, «1» — 30 sec
Нажмите «P»
pause, «2» — 60 sec pause, ... «8» — 240 sec pause
«8» will light, press «Р»
Pressing «+» or «-» choose the function value: «Y» — on, «n» — off,
(factory setting — «n»)
Pressing «+» or «-» choose the function value: «0» — off,
«1» — small reverse, «2» — medium reverse, «3» — large
reverse
+
-
P
The display shows «r»
OPERATOR PROGRAMMING
On the remote transmitter, select the button you want to control the
operator with and press it twice.
Press «P» to save the settings
Press «P» to save the settings
P
Press «P» to save the settings
Press and hold button «P» for ten seconds. The
display will stop flashing «r» and the Board will reboot,
you will hear a short beep.
+
-