DABIR D2-3S2340-05-0H 설치 매뉴얼

{카테고리_이름} DABIR D2-3S2340-05-0H에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DABIR D2-3S2340-05-0H 2 페이지.

Surface Installation Guide (D2 Models Only)

Important Before You Start: THIS IS A "QUICK SET-UP" GUIDE ONLY

Please refer to the Dabir Operation / Service Technical Manual for full set-up and usage instructions. Failure to carefully read and

follow all instructions and safety information may result in decreased product performance or injury.

Surface Installation

1. Place Dabir Surface onto flat mattress with "THIS SIDE UP" facing up (gray side down) and secure optional corner straps when

applicable. (Surface should lay flat when properly installed.) Hose exit orientation is optional depending on the desired set-up.

2. Place facility supplied linen and incontinence pad(s) over the top of the Dabir Surface and tuck edges underneath the mattress.

Avoid wrinkles whenever possible to optimize Dabir performance and patient comfort.

Dabir Surface

(Gray Side Down)

STEPS 1 & 2: Bed Installation

System Installation - Surface Connections

3. Insert Surface connector as shown.

4. Listen for an insertion "CLICK" to confirm proper connection.

NOTE: Therapy will start automatically if powered "ON".

WARNINGS / CAUTIONS:

•

Surfaces are intended to be used ABOVE an underlying bed mattress

with good pressure redistribution properties over the full patient contact area.

•

Always place the Surface ABOVE the mattress and cover it with a bed linen.

•

Surfaces are NOT intended to be used in direct contact with the patient's skin.

•

It is the responsibility of the user to secure and protect against patient movement and/or falls.

•

Therapy is NOT provided unless the Controller is powered "ON" and the Surface is actively cycling.

•

To avoid depressurization noise, do NOT unplug Surface connector while System is activated.

•

It is the responsibility of the user to properly clean and disinfect the System prior to patient use.

Corporate Headquarters, Sales & Manufacturing:

Dabir Surfaces, Inc., 7447 West Wilson Ave., Harwood Heights, IL 60706, USA, www.dabir-surfaces.com

Sales Inquiries:

[email protected], Tel: +1(888)559-3641

Technical Support:

[email protected], Tel: +1(888)559-3642

DOC# R02-0006-00054-CA

Bed Installation Diagram

Surface

Connector

STEPS 3 & 4: Connector Insertion

Incontinence Pad

Linen or Fitted Sheet

Dabir Surface

(Gray side down)

Mattress with good pressure

redistribution properties