Astralpool DECKWELL 설치 매뉴얼 - 페이지 15

{카테고리_이름} Astralpool DECKWELL에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Astralpool DECKWELL 17 페이지. Swimming pool flat telescopic platform

페이지 인쇄



CONSEILS D´ENTRETIEN / MAINTENANCE TIPS / CONSEJOS DE MANTENIMIENTO:

Spots of tree resin.

For stains caused by tree resin, clean using a cloth moistened with alcohol Ethyl. Do not apply directly ethyl alcohol leaving it, since it can stain the stage.

Stains Oxide.

For stains, apply stain "Ferrokit". Leave it to dilute the stain and rinse.

Spots decaying organic matter.

Use diluted bleach solution, then scrub with a brush, then rinse thoroughly.

Difficult, unknown or stains.

For stubborn stains of unknown nature, follow different cleaning steps:

•

Water

•

Cleansing soap

•

Diluted bleach (subsequent rinsing with water)

•

Bleach concentrated (subsequent rinsing with water)

•

Dilute hydrochloric acid (posterior and immediate rinsing with water)

Burnings or surface damage on stage.

For alterations or damage (burns, discoloration by external agents) of the surface of the floors, wipe with a scotch or small grain sandpaper. On the sanded

surface will be a slight change of tone, which can be compared to the rest of the stage with time.

Snow.

To remove the snow, you can use coarse salt and let melt.

Periodic cleaning.

For any stain act as quickly as possible to prevent surface absorption.

Although installation Tarimatec® none outstanding stain, and does not need any maintenance, you should carry out general cleaning every 3 to 6 months,

depending on use and area installation, for better appearance and beauty of your installation. To do this, perform cleanup following the following steps:

•

Use water jet machine pressure (max. 80 bar) with the jet fan or open and run the water within the meaning of grooving of the stage, avoid circular

movements and that leave marks on stage. This will help us remove embedded dirt and dust.

•

In a bucket with little water, pour a dash of soap and bleach cleaner, and with a broom clean, rub vigorously in different directions, to create foam. Leave for

minutes and rinse with plenty of water and avoid puddles. Allow to dry. Depending on the size of the facility, this cleaning should be done at once or in several

areas times.

Tarimatec® surface layer is porous, but the pores are shallow, therefore any stain can remove sanding. If the stain has penetrated the platform, you can sand the

surface with fine sandpaper or wire brush, always in the direction of grooving. This process will produce a slight whitening the area that will be planed matching

the rest of the flooring over time. Except for sudsy cleaner, always perform a clean test in an inconspicuous place of the platform, to observe the results. Strictly

follow the cleaning instructions. The use of other cleaning or improper use, are the sole responsibility of the customer.

Tarimatec® is not resistant to acetone, strong acids, silicones and paints.

*Prescription TARIMATEC

www.tarimatec.com

SPV005 Ed.170207 - Deckwell