DoorHan PCB-SH380 빠른 시작 매뉴얼 - 페이지 6
{카테고리_이름} DoorHan PCB-SH380에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorHan PCB-SH380 8 페이지. Control board
페이지 인쇄9. Open wicket sensor and optokit (X4, X5, X7 terminal blocks)
Connect the wicket sensor and optokit to the «OPEN», «CLOSE», «STOP», «Ph.CL», «-» and «+» terminals.
2. OPERATOR PROGRAMMING
2.1. SELECTING OPERATING MODE
The choice of operating mode is carried out by pressing the «P» button. The number of clicks will correspond to the number
of the selected mode of operation:
•
one press — operating mode #1;
•
two presses — operating mode #2;
•
three presses — operating mode #3.
Operating mode
1
2
3
2.2. AUTOMATIC CLOSING SETTING
Press and hold the «P» button, the «P» indicator will light up and after three seconds it will go out, then release the «P» button.
Wait the required time for the automatic closing timer and press the «P» button again (minimum time for automatic closing is
5 seconds, maximum time is 5 minutes).
NOTE. To disable automatic closing, set the time less than 5 seconds.
2.3. MOTOR OPERATING MODES
Motor timing:
•
60 seconds (default);
•
100 seconds.
60 seconds operating mode — when power is supplied to the board, the «P» indicator turns on and off for a short time.
100 seconds operating mode — when power is supplied to the board, the «P» indicator does not turn on.
To choose 60 / 100 seconds operating mode press and hold the «P» button, then, without releasing the button, supply power
to the board.
6
3-positios control post
Open wicket sensor
Door opening
pulse pressing of «Open» button
pulse pressing of Open» button
holding of «Open» button
Box on wall
Box on door panel
Optokit
Door closing
holding of «Clos»e button
pulse pressing of «Close» button
holding of «Close» button
OPERATOR PROGRAMMING
Automatic closing
yes
yes
yes