Canon PIXMA MP460 매뉴얼

{카테고리_이름} Canon PIXMA MP460에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon PIXMA MP460 4 페이지. Canon pixma mp460 quick setup (spanish)
Canon PIXMA MP460에 대해서도 마찬가지입니다: 사용자 설명서 (2 페이지), 보충 설명서 (1 페이지), 브로셔 (2 페이지), 보충 설명서 (6 페이지), 서비스 참조 매뉴얼 (10 페이지), 여기에서 시작 (2 페이지), (설치 지침 (2 페이지)

페이지 인쇄

Canon 30-241 Ink Cartridge Reset – Pixma iP/MP/MX/MG Series

The following procedures may be used to reset the Canon printer ink level monitoring

following the installation of a refilled Canon 30, 31, 40, 41, 50, 51, 210, 211, 240, or 241

integrated ink cartridge. In most cases, the error/alert will need to be cleared to enable

printing. Ink waste container reset procedures are also provided below.

NOTE:

for multi-cartridge installation, the procedure(s) may need to be repeated twice.

A. Pixma iP/MP/MX/MG Ink Counter Reset*

a. At computer screen message, select 'Stop'/'Reset', 'OK', or 'Resume',

or....

b. Select 'Stop'/'Reset', 'OK' or the 'Resume' button (triangle-circle icon) on your printer for 5

seconds.

Printing may continue under the 'ink out' condition.

B. Pixma iP Ink Counter Reset**

a. Press and Hold the Resume (triangle-circle) button

b. Press and Hold the Power Button; hold both buttons for 5 seconds

c. Release the Resume (triangle-circle) button.

d. Press the Resume button 5 times.

e. Release the Power button. The blinking ink level/power light should go steady after a few

seconds.

Printing may continue under the 'ink out' condition.

C. Pixma MP/MX/MG Series: General Printer & Ink Counter Reset***

a. Press the power button to turn off the printer.

b. Hold the "Stop/Reset" button while pushing the power button. While still holding down the

power button, release the "Stop/Reset" button and then push it twice in a row.

c. Wait approximately 20 to 30 seconds until the LED shows 0.

d. Push the "Stop/Reset" button four (4) times in a row.

e. Push the power button twice.

Turn off the printer by pushing the power button one more time. The printer is now reset.

Next, reset the cartridge ink counter:

a. Unplug the power and the USB cables from the printer.

b. Open the cartridge door and hold down the power button.

(UNIVERSAL RESET Procedure #1)

(Procedure #2)

(Procedure #3.a)