Canon PIXMA MP499 네트워크 설정 매뉴얼 - 페이지 8
{카테고리_이름} Canon PIXMA MP499에 대한 네트워크 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon PIXMA MP499 24 페이지. Obtaining network key
Canon PIXMA MP499에 대해서도 마찬가지입니다: 네트워크 설치 매뉴얼 (17 페이지), 네트워크 매뉴얼 (22 페이지), 네트워크 매뉴얼 (16 페이지), 매뉴얼 (13 페이지), 매뉴얼 (10 페이지)
페이지 인쇄
- 1. Table of Contents
- 2. The Target Access Point Is Not Displayed (Detected) on the Detected Access Points
- 3. Set Printer Ip Address Screen Is Displayed
- 4. The Machine Is Not Displayed (Detected) on the Detected Printers List Screen
- 5. Problems During Network Setup
- 6. Configuring Wireless Lan Settings Manually
- 7. Other Troubleshooting Tips
- 8. Restoring the Machine's Default Lan Settings to Perform Setup Again
Glossary
•
IP address
A numerical identification assigned to each computer or network device connected to a network.
•
IP address filtering
A function to allow or block traffic from network devices with specified IP addresses.
•
DHCP function
A function to automatically assign required information (IP address, etc.) to computers, printers or other
devices connected to the network.
•
Privacy separator feature
A function to prevent communication between multiple wireless devices (such as computers and
printers) connected to an access point.
Problems during Network Setup
WPS
"E > 2 > 0" is Displayed
Action
The error appears when attempting to configure LAN
settings of the machine from the Operation Panel while
they are being configured in another way. Configure the
settings after completing the settings.
"E > 2 > 3" is Displayed
Action
The message appears when multiple access points are
detected.
Wait for a while, then configure the settings again.
"E > 2 > 4" is Displayed
Check
The message appears when an error occurs.
Check the access point settings, then configure WPS
settings again.
•
For details on how to check the settings of the access point, refer to the manual supplied with the
access point or contact its manufacturer.
•
For the procedure to configure WPS settings of the machine, refer to "Wireless Setup Using WPS
(Wi-Fi Protected Setup)" in the printed manual: Getting Started.
•
When using an access point that does not support WPS, configure the settings by referring to "6
Set Up a Wireless Connection" in the printed manual: Getting Started.