Canon PIXMA MP990 네트워크 설정 매뉴얼 - 페이지 13

{카테고리_이름} Canon PIXMA MP990에 대한 네트워크 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon PIXMA MP990 16 페이지. Installing your multifunction on additional computers
Canon PIXMA MP990에 대해서도 마찬가지입니다: 기능 설명서 (12 페이지), 기술 사양 (2 페이지), 네트워크 매뉴얼 (24 페이지), 네트워크 매뉴얼 (19 페이지), 매뉴얼 (10 페이지), 네트워크 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (8 페이지)

페이지 인쇄
Canon PIXMA MP990 네트워크 설정 매뉴얼

Connection Checklist

Check
Check 1
Before connecting the machine, are the computer and network device (router, access point, etc.) configured and can the computer connect to the network?
Configure the computer and network device.
•
For the procedures, refer to the manuals supplied with the computer and network device, or contact their manufacturers.
Check 2
Are the machine and network device (router, access point, etc.) turned on?
Turn on each device.
If the machine is already turned on, turn it off, then turn it back on.
Check 3
Is the firewall function of your security software active?
A message may appear on the computer monitor warning that Canon software is attempting to access the network.
If the warning message appears, set the security software to always allow access.
Check 4
When establishing a connection over a wireless LAN, is the Wi-Fi lamp (A) lit blue?
Press the HOME button, then using the Easy-Scroll Wheel and OK button, select Settings > Device settings > LAN settings > WLAN
active/inactive > Wireless LAN active to enable wireless LAN.
•
After enabling wireless LAN, perform setup again by following the procedures in "Wireless Setup" on page 23 and onward in the printed manual: Getting
Started.
Check 5
Are the access point and machine installed in an open space where wireless communications are possible? Also, is there a microwave oven, refrigerator, etc. nearby?
Install them in an open space with as few obstacles as possible.
To prevent radio interference, leave some space between the installation location and a microwave oven, refrigerator, etc.
A