Canon PIXMA MP990 네트워크 설정 매뉴얼 - 페이지 9
{카테고리_이름} Canon PIXMA MP990에 대한 네트워크 설정 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon PIXMA MP990 16 페이지. Installing your multifunction
on additional computers
Canon PIXMA MP990에 대해서도 마찬가지입니다: 기능 설명서 (12 페이지), 기술 사양 (2 페이지), 네트워크 매뉴얼 (24 페이지), 네트워크 매뉴얼 (19 페이지), 매뉴얼 (10 페이지), 네트워크 설치 매뉴얼 (19 페이지), 설치 매뉴얼 (8 페이지)
페이지 인쇄
Reference Information
Entering the Access Point's Wireless LAN Settings Directly on the
Machine
Action
Enter the access point name/network name (SSID) and security setting (WEP, WPA,
etc.) on the machine directly.
Follow the procedure below.
1
Use the Easy-Scroll Wheel to select Settings, then
press the OK button.
2
Select Wireless LAN setup, then press the OK button.
3
Select Yes, then press the OK button.
•
When wireless connection is enabled, the Wi-Fi lamp lights
blue.
4
Select Easy settings, then press the OK button.
5
Select Directly enter the access point name, then
press the OK button.
•
If you are living in an apartment, nearby access points in use
may be detected.
6
Enter the access point name/network name (SSID)
using the Easy-Scroll Wheel, then press the OK button.
Use the Easy-Scroll Wheel to select the character. Use the ]
button to move the cursor to the right.
•
Enter the same access point name/network name (SSID) as
that of the access point on the machine.
•
For details on how to check the access point name/network
name (SSID), refer to the manual supplied with the access
point or contact its manufacturer.
•
Enter upper and lower case letters of the alphabet correctly. Letters are case sensitive.
7
Select a security protocol for the access point, then
press the OK button.
•
Go to either of the following steps according to the selected
security protocol.
Disable
WEP
WPA/WPA2
•
When WEP 40 bit is selected in AirPort Utility (AirPort Admin Utility), select WEP (64 bit).
•
When WEP (Transitional Security Network) is selected in AirPort Utility, select WEP (128
bit) or WPA2-PSK (AES).