DoorKing 1620-081 설치 매뉴얼 - 페이지 8

{카테고리_이름} DoorKing 1620-081에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DoorKing 1620-081 16 페이지. Surface mount vehicular lane barrier accessory

페이지 인쇄

Entry Lane Only In-Ground Loop Options

Before attempting to connect any wiring to the operator, be sure that the

circuit breaker in the electrical panel is in the OFF position. Permanent wiring

must be installed to the operator as required by local electrical codes. It is

recommended that a licensed electrical contractor perform this work.

Loop detector wiring shown is for DoorKing model 9409 Dual Channel

plug-In loop detector only.

If using other loop detectors refer to their Loop Information Manual for

installation instructions, loops/preformed loops and wiring diagrams.

All inputs to the main terminal are NORMALLY OPEN.

Typical DIP-Switch Settings

OFF

Switch 4 is ON.

OFF

Switch 7 is OFF (Timer). The arm

will rotate down after the vehicle

OFF

clears the down loop.

SW 1

See timer note below.

OFF

Switch 5 is ON. The lowering arm

OFF

will instantly reverse when photo

sensor gets blocked.

OFF

SW 2

Arming Loop Note: The arming loop only allows the access control device to function when a vehicle is on the

loop, otherwise it will not function. This prevents pedestrians from gaining access through the vehicular gate.

Timer Note: The timer can be used with a down loop. When timer is ON with a down loop, it will start countdown

when the arm has fully raised. Activation of the down loop will cancel timer countdown. Useful when an access

control device OR ticket spitter has been activated but vehicle does not move forward to activate the down loop.

The arm will remain UP. Timer will time out and lower the arm without the down loop being activated.

1620-065-G-8-20

LOOP

Com

Down

Loop

Port

DOWN

LOOP

9409

Dual Channel

Main Terminal

1 2 3 4 5

If the ARMING LOOP is

not used, then a single

channel loop detector

can be used (9410) in the down loop port.

Connect the down loop to loop 1 on this

detector. Connect the access control device

directly to main terminal 6 and 14.

DoorKing offers a free "Loop and

Loop-Detectors Information

Manual" PDF located at

DoorKing's web site for more

information. www.doorking.com

TIME

DELAY

DIP

SW 1

Switches

1601-010

POWER

SW 2

REVERSE

SENSITIVITY

Photo

Sensor

NC NO

See page 8.

7 8

10 11 12 13

Type of wiring to be used on ALL external devices:

A) Type CL2, CL2P, CL2R, or CL2X.

B) Other cable with equivalent or better electrical,

mechanical, and flammability ratings.

Down Loop

1 Ft. Minimum Distance

N O T A W A L K W AY

Arming Loop

for Access Control Device

Com

(Optional)

Access

Ticket Eject Loop

Control

for Ticket Spitter (Required)

Device

Ticket

Spitter