페이지 인쇄
Fit base and base board: see instructions for Akva bases
Position the base boards on the base frame and connect them with the four black
„legs". Secure with the fixing paddles using the outer holes.
The base boards are to be positioned so that the threaded pins point upwards (see
illustration).
Fit the bottom of the cover so that the AKVA logo is located at the foot end. Remove
the top, place the fixing paddles in the holes at the bottom of the cover and secure
them by inserting them in the holes in the base boards.
Place the head and foot end foams in the cover. Loosely fasten the allen screws through
the bracket in the base board pin.
Place the side foams in the cover likewise. Only loosely fasten the screws.
Afterwards, secure the wooden multiplex framework in the corners.
Place the corner foam inset to close the softside corners.
AKVA Soft Q