Canon PIXMA MX420 Series 네트워크 설정 문제 해결 - 페이지 13
{카테고리_이름} Canon PIXMA MX420 Series에 대한 네트워크 설정 문제 해결을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon PIXMA MX420 Series 34 페이지. Cartridge reset
Canon PIXMA MX420 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (24 페이지), 사양 (2 페이지), 네트워크 설치 매뉴얼 (14 페이지), 네트워크 설정 매뉴얼 (9 페이지), 설정 (29 페이지), 매뉴얼 (4 페이지)
페이지 인쇄
5
Select Advanced setup, then press the OK button.
6
Select Directly enter the access point name, then
press the OK button.
•
If you are living in an apartment, nearby access points in
use may be detected.
7
Enter the access point name/network name (SSID)
using the Numeric buttons, then press the OK button.
For details on how to enter characters, refer to "Character
Entry" on page 10.
•
Enter the same access point name/network name (SSID)
as that of the access point on the machine.
•
For details on how to check the access point name/network name (SSID), refer to the
manual supplied with the access point or contact its manufacturer.
•
Enter upper and lower case letters of the alphabet correctly. Letters are case sensitive.
•
2-byte characters are not available for entering the access point name/network name
(SSID).
8
Make sure that the access point name/network name
(SSID) is correct, then press the OK button.
9
Select a security protocol for the access point, then
press the OK button.
•
Go to either of the following steps according to the selected
security protocol.
Go to
Disable
13.
Go to
WEP
page 13.
Go to
WPA/WPA2
page 13.
•
When WEP 40 bit or WEP 128 bit is selected in AirPort Utility (AirPort Admin Utility), select
WEP.
•
When WEP (Transitional Security Network) is selected in AirPort Utility, select WPA2-PSK
(AES).
•
When the access point is set to operate in IEEE802.11n, TKIP cannot be used. Change the
encryption type to something other than TKIP or change the standard to something other
than IEEE802.11n, then configure wireless LAN settings again.
•
When the access point is set to operate in IEEE802.11n and IEEE802.11g with TKIP set as
an encryption standard, communication is established using IEEE802.11g.
on page
. on
on