Canon PIXMA MX522 매뉴얼

{카테고리_이름} Canon PIXMA MX522에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Canon PIXMA MX522 4 페이지. Cartridge reset
Canon PIXMA MX522에 대해서도 마찬가지입니다: 간편한 설정 (2 페이지), 설정 매뉴얼 (31 페이지), 시작하기 (4 페이지), 매뉴얼 (8 페이지)

페이지 인쇄

Canon 30-241 Ink Cartridge Reset – Pixma iP/MP/MX/MG Series

The following procedures may be used to reset the Canon printer ink level monitoring

following the installation of a refilled Canon 30, 31, 40, 41, 50, 51, 210, 211, 240, or 241

integrated ink cartridge. In most cases, the error/alert will need to be cleared to enable

printing. Ink waste container reset procedures are also provided below.

NOTE:

for multi-cartridge installation, the procedure(s) may need to be repeated twice.

A. Pixma iP/MP/MX/MG Ink Counter Reset*

a. At computer screen message, select 'Stop'/'Reset', 'OK', or 'Resume',

or....

b. Select 'Stop'/'Reset', 'OK' or the 'Resume' button (triangle-circle icon) on your printer for 5

seconds.

Printing may continue under the 'ink out' condition.

B. Pixma iP Ink Counter Reset**

a. Press and Hold the Resume (triangle-circle) button

b. Press and Hold the Power Button; hold both buttons for 5 seconds

c. Release the Resume (triangle-circle) button.

d. Press the Resume button 5 times.

e. Release the Power button. The blinking ink level/power light should go steady after a few

seconds.

Printing may continue under the 'ink out' condition.

C. Pixma MP/MX/MG Series: General Printer & Ink Counter Reset***

a. Press the power button to turn off the printer.

b. Hold the "Stop/Reset" button while pushing the power button. While still holding down the

power button, release the "Stop/Reset" button and then push it twice in a row.

c. Wait approximately 20 to 30 seconds until the LED shows 0.

d. Push the "Stop/Reset" button four (4) times in a row.

e. Push the power button twice.

Turn off the printer by pushing the power button one more time. The printer is now reset.

Next, reset the cartridge ink counter:

a. Unplug the power and the USB cables from the printer.

b. Open the cartridge door and hold down the power button.

(UNIVERSAL RESET Procedure #1)

(Procedure #2)

(Procedure #3.a)